Make toy cars with rubber bands, a lot of fun to do with children. Rubber bands can be used for electricity or drive. A car that uses a mousetrap is a fast little car 'entertainment. The spring of the mousetrap is the free energy to the wheels that are wrapped in rubber bands for traction. They meet a couple of neighborhood kids and make more than one race. Adult supervision is strongly recommended to build a toy car with rubber bands. And the fun is mandatory.
They meet for all deliveriesto build a mousetrap car. This car needs a mousetrap, Saw 2 metal rods, 4 screws eye small, some plywood, rubber bands, string, washers, rods that are part of a drill bit and set ', coping saw or jigsaw, a hammer, a file in a vice and file a wooden jewelry., wood and about 2 part epoxy glue and a drawing compass
Begin by holding down the mouse trap and pull out the wire, that the case open with pliers. Keep this line for later use. Remove the bracket for the baitMousetrap. Remove all staples that may be present.
With eye hooks, screw them into one end of the trap. Put 8 mm from the edge of the trap. Drill a small hole starting to keep the wood from splitting.
Drawing on the drawing compass at 2, 75 mm circles on the plywood. Cut with a hacksaw. File edges smooth with a file in wood.
Place strips side by side and see if they have exactly the same size. Cut the correct length of the file and, if necessary. Withthe hacksaw, cut about half of a stick. File the cut wider enough for the wire 1 through the rest away
Cut the wire from point 1 to 7 mm. Stick the end of this wire into the slot straight cut with epoxy resin 2 parts. They should dry overnight.
Place the wire, which is now dry on the back of the mousetrap. Slide Connect the other wire through the loop.
Place the slices on the wire. With the tip 3.7 mm drill and drill a hole in the centerwheels. Slide the wheels on the rails.
Tie the string to the central terminal on the mousetrap. Lengthen the string to the end and tie it to the bridge. Cut open.
Wrap rubber bands around the wheels. Stick it in place.
Lift the lip of the box enough to get the end of the string loop over the wire to the rear axle. Pull the car back so that the string winds around the axle and the elevators to the terminal mousetrap. Sit on the floor of the car and letgo.
No comments:
Post a Comment